3D Slider 33 by #LVS

Method:
Apply Bond by #LVS or Bond + by #LVS to the nail that is prepared for the slider and harden it for 10 seconds. out in the curing light.
Cut the desired design from the slider, place it on a damp gel sponge or soak it in some water in your dap in dish.
Remove the print layer and apply it to the nail.
Push away any ridges from the center with your silicone tool.
If you still have some raised edges, you can carefully remove them with Bond by #LVS or Bond + by #LVS.

Apply a Rubberbase, Brush on Fiber of Brush 'n Love  if desired for the adhesion of the slider.
Finish the nail with one of the flexible top coats by #VS.

For inspiration and Step by Steps we would like to refer you to our Instagram page where you can see different possibilities with the Sliders on our IGTV and our FEED (overview).